Component Inspection (VVEL ACTUATOR SUB ASSEMBLY)

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

CHECK VVEL ACTUATOR SUB ASSEMBLY
1. Turn ignition switch OFF.
2. Remove VVEL actuator sub assembly. Refer to "DISASSEMBLY AND ASSEMBLY ".
3. Turn the ball screw shaft to check that it works smoothly.
  Is the inspection result normal?
  
  YES: INSPECTION END
  
  NO: GO TO 2.
REPLACE VVEL ACTUATOR SUB ASSEMBLY
1. Replace VVEL actuator sub assembly.
2. Perform "SPECIAL REPAIR REQUIREMENT ".
  : INSPECTION END