Removal and Installation: Removal: Preparation

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

Remove engine cover, engine room cover (RH and LH), battery cover and brake master cylinder cover. Refer to "EXPLODED VIEW ".
Release fuel pressure. Refer to "INSPECTION ".
Remove the following parts:
- Engine undercover (power tool)
- Front road wheel and tires (power tool)
- Cowl top cover: Refer to "EXPLODED VIEW ".
- Air duct, air cleaner case assembly and PCV hose: Refer to "EXPLODED VIEW ".
- Drive belts: Refer to "REMOVAL AND INSTALLATION ".
- Front cross bar: Refer to "EXPLODED VIEW ".
Disconnect both battery cables. Refer to "EXPLODED VIEW ".
Drain engine coolant from radiator. Refer to "DRAINING ".
CAUTION: Perform this step when engine is cold.
Discharge refrigerant from A/C circuit. Refer to "COLLECTION AND CHARGE ".
Remove radiator hoses (upper and lower). Refer to "EXPLODED VIEW ".