Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

Note the following item, and install in the reverse order of removal.

Do not allow engine mounting insulator to be damage and careful no engine oil gets on it.
For a location with a positioning pin, insert it securely into hole of matching part.
For a part with a specified installation orientation, refer to component figure in "EXPLODED VIEW ".
When installing engine mounting bracket (RH and LH) on cylinder block, tighten two upper bolts (A) first. Then tighten two lower bolts (B).

Fig 1: Engine Mounting Bracket (RH And LH) Upper And Lower Bolts With Tightening Sequence
Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: This figure shows an example of bank 2.
When installing engine mounting bracket (rear) on transfer, tighten two upper bolts (B) first. Then tighten two lower bolts (C).

Fig 2: Rear Engine Mounting Member Bolts With Tightening Sequence
Courtesy of NISSAN NORTH AMERICA, INC.
When installing engine mounting insulator (rear) on engine mounting bracket (rear), tighten upper bolts (D) first. Then tighten lower bolts (E).
Tighten rear engine mounting member bolts in numerical order as shown in the figure below.

Fig 3: Rear Engine Mounting Member Bolts With Tightening Sequence
Courtesy of NISSAN NORTH AMERICA, INC.
Check that all engine mounting insulators are seated properly, then tighten mounting nuts and bolts.