LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical) >> Unit Disassembly And Assembly >> How To Select Piston And Bearing >> Connecting Rod Bearing >> When New Connecting Rod And Crankshaft Are Used

When New Connecting Rod And Crankshaft Are Used

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply connecting rod big end diameter grade stamped (D) on connecting rod side face to the row in the "CONNECTING ROD BEARING SELECTION TABLE ".
    Fig 1: Locating Connecting Rod Big End Diameter Grade Stamped On Connecting Rod
    G09000419Courtesy of NISSAN NORTH AMERICA, INC.
  2. Apply crankshaft pin journal diameter grade stamped on crankshaft front side to the column in the "CONNECTING ROD BEARING SELECTION TABLE "
    Fig 2: Locating Crankshaft Pin Journal Diameter Grade Stamped On Crankshaft
    G09000420Courtesy of NISSAN NORTH AMERICA, INC.
  3. Read the symbol at the cross point of selected row and column in the "CONNECTING ROD BEARING SELECTION TABLE ".
  4. Apply the symbol obtained to the "CONNECTING ROD BEARING GRADE TABLE " to select connecting rod bearing.
scientia non olet · About LEMON Manuals