LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical) >> Removal And Installation >> Oil Seal >> Front Oil Seal >> FRONT OIL SEAL: Removal and Installation >> Installation

FRONT OIL SEAL: Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install front oil seal on front cover.
    • Apply new engine oil to both oil seal lip (A) and dust seal lip (B).
    • Install it so that each seal lip is oriented as shown in the figure below.
      CAUTION: Be careful not to scratch or make burrs on circumference of oil seal.
    • Using a suitable drift [outer diameter: 56 mm (2.20 in)], press-fit oil seal until it becomes flush with front cover end face.
    • Check the garter spring is in position and seal lips are not inverted.
    Fig 1: Locating Oil And Dust Seal Lips
    G09000226Courtesy of NISSAN NORTH AMERICA, INC.
  2. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals