LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Mechanical) >> Periodic Maintenance >> Drive Belts >> Checking

Drive Belts: Checking

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Be sure to perform the these steps when engine is stopped.
  • Remove air duct (inlet) when inspecting alternator, water pump and A/C compressor belt.
  • Remove engine undercover with power tool when inspecting power steering oil pump belt.
  • Check that the indicator (A) (notch on fixed side) of each auto-tensioner is within the possible use range (B).
NOTE:
  • Check the each auto-tensioners indication when the engine is cold.
  • When new drive belts is installed, the indicator (notch on fixed side) should be within the range (C) in the figure.
  • Visually check all drive belts for wear, damage or cracks.
  • If the indicator (notch on fixed side) is out of the possible use range or drive belts are damaged, replace drive belts.
scientia non olet · About LEMON Manuals