Component Inspection

REMOVE FUEL LEVEL SENSOR UNIT
Remove the fuel level sensor unit. Refer to "REMOVAL AND INSTALLATION ".

: GO TO 2.

CHECK FUEL LEVEL SENSOR UNIT AND FUEL PUMP (MAIN)

Check the resistance between fuel level sensor unit and fuel pump (main).

Fuel level sensor unit and fuel pump (main)

Condition⁽¹⁾

Resistance (Approx.)

Terminal

Full (A)

2.5 Ω

Empty (B)

81.5 Ω

⁽¹⁾	When float rod is contact with stopper.

Fig 1: Identifying Fuel Level Sensor Unit And Fuel Pump Float Position (Empty And Full Conditions)

Courtesy of NISSAN NORTH AMERICA, INC.

STANDARD FLOAT POSITION

Float position [mm (in)]⁽¹⁾

Full (A)

Approx. 192 (7.56)

Empty (B)

Approx. 32 (1.26)

⁽¹⁾	When float rod is contact with stopper.

Is the inspection result normal?

YES: GO TO 3.

NO: Replace fuel level sensor unit and fuel pump (main).

CHECK FUEL LEVEL SENSOR UNIT (SUB)

Inspect the resistance of fuel level sensor unit (sub).

Fuel level sensor unit (sub)

Condition⁽¹⁾

Resistance (Approx.)

Terminal

Full (A)

2.5 Ω

Empty (B)

42.5 Ω

⁽¹⁾	When float rod is contact with stopper.

Fig 2: Identifying Fuel Level Sensor Unit Float Position (Empty And Full Conditions)

Courtesy of NISSAN NORTH AMERICA, INC.

STANDARD FLOAT POSITION

Float position [mm (in)]⁽¹⁾

Full (A)

Approx. 35 (1.38)

Empty (B)

Approx. 203 (7.99)

⁽¹⁾	When float rod is contact with stopper.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace fuel level sensor unit (sub).