Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect inverter unit connector and AC 120 V outlet main switch connector.
3. Check continuity between inverter unit harness connector and AC 120 V main switch harness connector.

   Inverter unit		AC 120 V outlet main switch		Continuity
   Connector	Terminal	Connector	Terminal
   M143	7	M144	5	Existed

4. Check continuity between inverter unit harness connector and ground.

   Inverter unit		Ground	Continuity
   Connector	Terminal
   M143	7		Not existed

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Repair the harnesses or connectors.

Check continuity between AC 120 V outlet main switch harness connector and ground.

Is the inspection result normal? 

YES: GO TO 3.

NO: Repair the harnesses or connectors.

1. Connect AC 120 V outlet main switch connector and inverter unit connector.
2. Turn ignition switch ON.
3. AC 120 V outlet main switch ON. (AC 120 V output is normal)
4. Check for voltage between the inverter unit harness connector and ground.

   Terminals			Condition	Voltage (Approx.)
   (+)		(-)
   Inverter unit		Ground	AC 120 V outlet main switch
   Connector	Terminal
   M143	7		OFF	0 V
   			ON	5.2 V

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Replace inverter unit.

1. AC 120 V outlet main switch ON. (AC 120 V output is normal)
2. Check that AC 120 V outlet main switch indicator is illuminated.

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Replace AC 120 V outlet main switch.