Component Inspection
- CHECK TRIP RESET AND ILLUMINATION CONTROL SWITCH
- Turn ignition switch OFF.
- Disconnect trip reset and illumination control switch connector.
- Check trip reset and illumination control switch.
Terminals Condition Continuity Trip reset and illumination control switch 5 6 When trip reset switch is pressed Existed Other than the above Not existed 3 When illumination control switch (+) is pressed Existed Other than the above Not existed 4 When illumination control switch (-) is pressed Existed Other than the above Not existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace trip reset and illumination control switch. Refer to "REMOVAL AND INSTALLATION ".