Diagnosis Procedure

1. Turn ignition switch ON.
2. Check voltage between combination meter harness connector and ground.

   Terminals			Voltage (Approx.)
   (+)		(-)
   Combination meter		Ground
   Connector	Terminal
   M53	34

   Does it match fuel gauge reading? 

   YES: GO TO 2.

   NO: Replace the combination meter. Refer to "REMOVAL AND INSTALLATION ".

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and fuel level sensor unit (sub) connector.
3. Check continuity between combination meter harness connector and fuel level sensor unit (sub) harness connector.

   Combination meter		Fuel level sensor unit (sub)		Continuity
   Connector	Terminal	Connector	Terminal
   M53	34	B21	1	Existed

4. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M53	34		Not existed

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair harness or connector.

1. Disconnect fuel level sensor unit (main) connector.
2. Check continuity between fuel level sensor unit (sub) harness connector and fuel level sensor unit (main) harness connector.

   Fuel level sensor unit (sub)		Fuel level sensor unit (main)		Continuity
   Connector	Terminal	Connector	Terminal
   B21	2	B241	2	Existed

3. Check continuity between fuel level sensor unit (main) harness connector and ground.

   Fuel level sensor unit (sub)		Ground	Continuity
   Connector	Terminal
   B21	2		Not existed

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair harness or connector.

Check continuity between fuel level sensor unit (main) harness connector and combination meter harness connector.

Is the inspection result normal? 

YES: INSPECTION END

NO: Repair harness or connector.