| Combination meter |
Controls the following with the signals received from each unit via CAN communication and the signals from switches and sensors.
- Speedometer
- Tachometer
- Assist charge gauge
- Fuel gauge
- Warning lamps
- Indicator lamps
- Meter illumination control
- Meter effect function
- Information display
|
| Meter control switch |
Transmits the following signals to the combination meter.
- Enter switch signal
- Select switch signal
- Trip reset switch signal
- Illumination control switch signal (+)
- Illumination control switch signal (-)
|
| HPCM |
Transmits the following signals to the combination meter via CAN communication.
- Engine speed signal
- Oil pressure warning lamp signal
- Engine coolant temperature signal
- Fuel consumption monitor signal
- Assist charge signal
- READY to drive indicator lamp signal
- Energy monitor signal
- Li-ion battery state of charge signal
- Acceleration guide signal
- EV indicator lamp signal
- Fuel filler cap warning display signal
- Hybrid system over heat warning signal
- Shift P warning signal
|
| ECM |
Transmits the following signals to the HPCM via CAN communication.
- Engine speed signal
- Oil pressure warning lamp signal
- Engine coolant temperature signal
- Fuel filler cap warning display signal
|
| ABS actuator and electric unit (control unit) |
Transmits the vehicle speed signal to the combination meter via CAN communication. |
| BCM |
Transmits the following signals to the combination meter via CAN communication.
- Dimmer signal
- Door switch signal
- Trunk switch signal
- Meter ring illumination request signal
- Meter display signal
- Intelligent Key system warning display signal
- Low tire pressure warning lamp signal
|
| TCM |
Transmits the following signals to the combination meter.
- Shift position signal
- Manual mode shift refusal signal
|
| A/T shift selector |
Transmits the following signals to the combination meter.
- Manual mode signal
- Non-manual mode signal
- Manual mode shift up signal
- Manual mode shift down signal
|
| Fuel level sensor unit |
Transmits the fuel level sensor signal to the combination meter. |
| Engine oil pressure sensor |
Transmits the engine oil pressure sensor signal to the ECM. |
| Ambient sensor |
Transmits the ambient sensor signal to the A/C auto amp. |
| A/C auto amp. |
Transmits the ambient sensor signal to the combination meter via CAN communication. |
| Parking brake switch |
Transmits the parking brake switch signal to the combination meter. |
| Washer level switch |
Transmits the washer level switch signal to the combination meter. |