LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2012 >> G37 IPL, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator (Coupe) >> DTC/Circuit Diagnosis >> Fuel Level Sensor Signal Circuit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK UNIFIED METER AND A/C AMP. INPUT SIGNAL
    1. Turn ignition switch ON.
    2. Check voltage between unified meter and A/C amp. harness connector terminal and ground.
    Terminal Voltage (Approx.)
    (+) (-)
    Unified meter and A/C amp.
    Connector Terminal
    M67 42 Ground
    G05223669Courtesy of NISSAN NORTH AMERICA, INC.

    Does it match fuel gauge reading? 

    YES: GO TO 2.

    NO: Replace the unified meter and A/C amp.

  2. CHECK FUEL LEVEL SENSOR (SUB) CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect unified meter and A/C amp. connector and fuel level sensor unit (sub) connector.
    3. Check continuity between unified meter and A/C amp. harness connector terminal and fuel level sensor unit (sub) harness connector terminal.
      Unified meter and A/C amp. Fuel level sensor unit (sub) Continuity
      Connector Terminal Connector Terminal
      M67 42 B21 1 Existed
    4. Check continuity between unified meter and A/C amp. harness connector terminal and ground.
    Unified meter and A/C amp. Ground Continuity
    Connector Terminal
    M67 42 Not existed

    Is the inspection result normal? 

    OK: GO TO 3.

    NG: Repair harness or connector.

  3. CHECK FUEL LEVEL SENSOR (MAIN-SUB) CIRCUIT
    1. Disconnect fuel level sensor unit and fuel pump (main) connector.
    2. Check continuity between fuel level sensor unit (sub) harness connector terminal and fuel level sensor unit and fuel pump (main) harness connector terminal.
      Fuel level sensor unit (sub) Fuel level sensor unit (main) Continuity
      Connector Terminal Connector Terminal
      B21 2 B22 2 Existed
    3. Check continuity between fuel level sensor unit (sub) harness connector terminal and ground.
    Fuel level sensor unit (sub) Ground Continuity
    Connector Terminal
    B21 2 Not existed

    Is the inspection result normal? 

    OK: GO TO 4.

    NG: Repair harness or connector.

  4. CHECK FUEL LEVEL SENSOR (MAIN) CIRCUIT

    Check continuity between fuel level sensor unit and fuel pump (main) harness connector terminal and unified meter and A/C amp. harness connector terminal.

    Fuel level sensor unit (main) Unified meter and A/C amp. Continuity
    Connector Terminal Connector Terminal
    B22 5 M67 58 Existed

    Is the inspection result normal? 

    OK: INSPECTION END

    NG: Repair harness or connector.

scientia non olet · About LEMON Manuals