Diagnosis Procedure

1. Start engine.
2. Check the operation of the parking brake warning lamp when operating the parking brake.

   Condition	Warning lamp status
   Parking brake ON	ON
   Parking brake OFF	OFF

   Is the inspection result normal? 

   YES: Replace combination meter.

   NO: GO TO 2.

1. Turn ignition switch OFF.
2. Check the parking brake switch signal circuit. Refer to "DIAGNOSIS PROCEDURE (A/T MODELS) " (A/T models) or "DIAGNOSIS PROCEDURE (M/T MODELS) " (M/T models).

   Is the inspection result normal? 

   YES: GO TO 3.

   NG: Repair harness or connector.

Perform a unit check for the parking brake switch. Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: Replace combination meter.

NO: Replace parking brake switch.