DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test:

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

This test may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 

: GO TO 2.

With CONSULT 

1. Wait until engine coolant temperature is less than 90°C (194°F)
   • Turn ignition switch ON.
   • Select "DATA MONITOR" mode with CONSULT.
   • Check the engine coolant temperature.
   • If the engine coolant temperature is not less than 90°C (194°F), turn ignition switch OFF and cool down engine.
   NOTE: Perform the following steps before engine coolant temperature is above 90°C (194°F):
2. Turn ignition switch ON.
3. Select "DATA MONITOR" mode with CONSULT.
4. Start engine.
5. Hold vehicle speed at more than 70 km/h (43 MPH) for 100 consecutive seconds.
   CAUTION: Always drive vehicle at a safe speed.
6. Check 1st trip DTC.

With GST 

Follow the procedure "With CONSULT" above.

Is 1st trip DTC detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END