Propeller Shaft Runout

WARNING: This page is about a different car, the 2011 Infiniti FX50 and 2011 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Check propeller shaft runout at measuring points with a dial indicator. If runout exceeds specifications, replace propeller shaft assembly.

Propeller shaft runout : Refer to "PROPELLER SHAFT RUNOUT ".

Fig 1: Measuring Propeller Shaft Runout

Courtesy of NISSAN MOTOR CO., U.S.A.

Propeller shaft runout measuring point (Point "Δ ")

Fig 2: Measuring Propeller Shaft Runout Measuring Point
Courtesy of NISSAN MOTOR CO., U.S.A.

Dimension

A : 162 mm (6.38 in)

B : 245 mm (9.65 in)

C : 185 mm (7.28 in)

Journal Axial Play

As shown in the illustration, while fixing yoke on one side, check axial play of joint. If it is outside the standard, replace propeller shaft assembly.

Journal axial play : Refer to "JOURNAL AXIAL PLAY ".

Fig 3: Checking Axial Play Of Journal

Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Never disassemble joints.