Component Inspection

WARNING: This page is about a different car, the 2011 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

EXHAUST VALVE TIMING CONTROL POSITION SENSOR-I
1. Turn ignition switch OFF.
2. Disconnect exhaust valve timing control position sensor harness connector.
3. Loosen the fixing bolt of the sensor.
4. Remove the sensor. Refer to "EXPLODED VIEW ".
5. Visually check the sensor for chipping.
  Is the inspection result normal?
  
  YES: GO TO 2.
  
  NO: Replace malfunctioning exhaust valve timing control position sensor. Refer to "EXPLODED VIEW ".
  
  Fig 1: Checking Camshaft Position Sensor-I
  Courtesy of NISSAN MOTOR CO., U.S.A.

EXHAUST VALVE TIMING CONTROL POSITION SENSOR-II

Check resistance exhaust valve timing control position sensor terminals as shown below.

RESISTANCE REFERENCE CHART

Terminals	Resistance
1 (+) - 2 (-)	Except 0 or ∞Ω [at 25°C (77°F)]
1 (+) - 3 (-)
2 (+) - 3 (-)

Is the inspection result normal?

YES: INSPECTION END

NO: Replace malfunctioning exhaust valve timing control position sensor. Refer to "EXPLODED VIEW ".