Component Inspection

WARNING: This page is about a different car, the 2011 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ACCELERATOR PEDAL POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage ECM harness connector terminals under the following conditions.

VOLTAGE REFERENCE CHART

ECM			Condition		Voltage (V)
Connector	+	-
Connector	Terminal	Terminal
M160	104 (APP sensor 1)	119	Accelerator pedal	Fully released	0.45 - 1.0
	104 (APP sensor 1)	119		Fully depressed	4.4 - 4.8
	108 (APP sensor 2)	115		Fully released	0.22 - 0.5
	108 (APP sensor 2)	115		Fully depressed	2.1 - 2.5

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Replace accelerator pedal assembly.
2. Perform "SPECIAL REPAIR REQUIREMENT ".
  INSPECTION END