LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2012 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Control System (VK50VE) - FX50 - DTC U0101, U0113, U1003, U1001, U1024, & P006A Through P0133 / P0153) >> DTC P010A: Manifold Absolute Pressure Sensor >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2011 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

      GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
    1. Start engine and let it idle for 10 seconds.
    2. Check DTC.

      Is DTC detected? 

      YES: Go to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About LEMON Manuals