LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (ATX90A)) >> Unit Removal And Installation >> Transfer Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove rear propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove front propeller shaft. Refer to "REMOVAL AND INSTALLATION "".
  3. Disconnect transfer control actuator, transfer rotary position sensor, transfer lock position sensor, transfer Hi-Lo position sensor and transfer fluid temperature sensor harness connectors and separate harnesses from transfer assembly.
  4. Remove transfer breather hose.
  5. Remove exhaust front tube (LH) with a power tool. Refer to "REMOVAL AND INSTALLATION ".
  6. Remove exhaust front tube (RH) with a power tool. Refer to "REMOVAL AND INSTALLATION ".
  7. Remove main muffler with a power tool. Refer to "REMOVAL AND INSTALLATION ".
  8. Support transfer assembly and transmission assembly with a jack.
    CAUTION: Secure transfer assembly and transmission assembly to a jack.
  9. Remove rear engine mounting member and engine mounting insulator with a power tool. Refer to "REMOVAL AND INSTALLATION ".
  10. Lower jack to the position where the top transfer mounting bolts can be removed.
  11. Remove transfer mounting bolts and separate transfer from transmission.
    CAUTION: Secure transfer assembly and transmission assembly to a jack.
scientia non olet · About LEMON Manuals