Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK TIRE
Check the following.
- Tire pressure
- Wear condition
- Front and rear tire size (There is no difference between front and rear tires.)
  Is the inspection result normal?
  
  YES: GO TO 2.
  
  NO: Repair or replace error-detected parts. And then, drive the vehicle at speed of 20 km/h (12 MPH) or more for 5 seconds or more. Improper size information is initialized accordingly.
TERMINAL INSPECTION
Check 4WD control unit harness connector for disconnection.

Is the inspection result normal?

YES: Replace transfer control unit. Refer to "REMOVAL AND INSTALLATION ".

NO: Repair or replace the error-detected parts.