LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (ATX90A)) >> Removal And Installation >> Transfer Lock Position Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF.
  2. Disconnect negative battery terminal.
    CAUTION: Wait for 5 seconds after turning ignition OFF.
  3. Support transfer assembly and transmission assembly with a jack.
  4. Remove rear engine mounting cross member with a power tool. Refer to "4WD : REMOVAL AND INSTALLATION ".
  5. Lower jack to the position where the transfer lock position sensor can be removed.
  6. Disconnect the transfer lock position sensor connector.
  7. Remove the transfer lock position sensor.
  8. Perform inspection after removal. Refer to "INSPECTION ".
scientia non olet · About LEMON Manuals