LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (ATX90A)) >> Removal And Installation >> Transfer Hi-Lo Position Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF.
  2. Disconnect negative battery terminal.
    CAUTION: Wait for 5 seconds after turning ignition switch OFF.
  3. Remove exhaust front tube (LH). Refer to "REMOVAL AND INSTALLATION ".
  4. Support transfer assembly and transmission assembly with a jack.
  5. Remove front suspension rear cross member with a power tool. Refer to "4WD : REMOVAL AND INSTALLATION ".
  6. Remove rear engine mounting cross member with a power tool. Refer to "4WD : REMOVAL AND INSTALLATION ".
  7. Remove heat insulator of exhaust front tube (LH).
  8. Lower jack to the position where the transfer Hi-Lo position sensor can be removed.
  9. Disconnect the transfer Hi-Lo position sensor connector.
  10. Remove the transfer Hi-Lo position sensor.
  11. Perform inspection after removal. Refer to "INSPECTION ".
scientia non olet · About LEMON Manuals