LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (ATX90A)) >> Removal And Installation >> Transfer Control Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF.
  2. Disconnect negative battery terminal.
    CAUTION: Wait for 5 seconds after turning ignition switch OFF.
  3. Remove the glove box assembly. Refer to "REMOVAL AND INSTALLATION ".
  4. Disconnect the transfer control unit connector.
  5. Move instrument lower cover to backward. Refer to "REMOVAL AND INSTALLATION ".
  6. Remove the transfer control unit.
scientia non olet · About LEMON Manuals