LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (ATX90A)) >> Removal And Installation >> Transfer Control Actuator >> Inspection >> Inspection After Removal

Inspection After Removal

WARNING: This page is about a different variant/trim than selected.
  1. Check the oil seal assembled transfer control actuator for wear, crack and damage. Replace if there is malfunction.
  2. Check the transfer assembly as follows.
    1. Install the spline socket (A) [SST: KV10119400 (-)] to transfer assembly in the figure.
    2. When turn the shaft in (B) direction, check returning to (C) direction by spring power.
      CAUTION: The maximum turning force shall be 30 N.m (3.1 kg-m, 22 ft-lb).
    3. When turn the shaft in (C) direction, check locking the shaft.
      Fig 1: Installing Spline Socket
      G07023562Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals