LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (ATX90A)) >> Removal And Installation >> Rear Oil Seal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the rear propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
  2. Put matching marks (A) on the end of the main shaft and the rear companion flange.
    CAUTION: For matching mark, using paint. Never damage main shaft.
  3. Remove the snap ring.
  4. Remove the adjusting shim.
  5. Remove the rear companion flange, using a plastic hammer.
    Fig 1: Identifying Matching Marks On End Of Main Shaft And Rear Companion Flange
    G07023553Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Remove the dust shield from rear companion flange, using the drift, puller and replacer.
    Fig 2: Removing Dust Shield
    G07023554Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove the o-ring from rear companion flange.
  8. Remove the rear oil seal from rear case.
    CAUTION: Never damage rear case and main shaft.
scientia non olet · About LEMON Manuals