LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (ATX90A)) >> Periodic Maintenance >> Transfer Fluid >> Inspection >> Fluid Level

Fluid Level

WARNING: This page is about a different variant/trim than selected.
  1. Remove filler plug (1) and gasket. Then check that fluid is filled up from mounting hole for the filler plug.
    CAUTION: Never start engine while checking fluid level.
  2. Set a new gasket onto filler plug (1), and install it on transfer and then tighten to the specified torque.

    Specified torque : 33 N.m (3.4 kg-m, 24 ft-lb) 

    Fig 1: Checking Fluid Level
    G07024796Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION: Never reuse gasket.
scientia non olet · About LEMON Manuals