Component Inspection
WARNING: This page is about a different variant/trim than selected.
- CHECK TRANSFER MOTOR TEMPERATURE SENSOR
- Turn the ignition switch OFF.
- Disconnect transfer control actuator harness connector.
- Check the resistance between transfer control actuator harness connector terminals.RESISTANCE SPECIFICATION
Transfer control actuator Condition Resistance Terminal 4 7 20°C (68°F) Approx. 12.5 kΩ 80°C (176°F) Approx. 1.3 kΩ Is the inspection result normal?
YES: INSPECTION END
NO: Transfer motor temperature sensor is malfunctioning. Replace transfer control actuator. Refer to "EXPLODED VIEW ".