Component Inspection

WARNING: This page is about a different variant/trim than selected.

CHECK TRANSFER MOTOR

Remove transfer control actuator. Refer to "EXPLODED VIEW ".
Apply 12 V to transfer control actuator connector No. 1 terminal and No. 8 terminal.
CAUTION:
- Never make the terminals short.
- Connect the fuse between the terminals when applying the voltage.

Check the operation of transfer control actuator.

TRANSFER CONTROL ACTUATOR CONDITION

Transfer control actuator		Condition	Operation
Terminal		Condition	Operation
1	8	Apply the voltage between No. 1 (+) terminal and No. 8 (-) terminal.	Operate clockwise
1	8	Apply the voltage between No. 1 (-) terminal and No. 8 (+) terminal.	Operate counterclockwise

Is the inspection result normal?

YES: INSPECTION END

NO: Replace transfer control actuator. Refer to "EXPLODED VIEW ".