Component Inspection

WARNING: This page is about a different variant/trim than selected.

CHECK 4WD SHIFT SWITCH

Turn the ignition switch OFF.
Remove 4WD switch assembly. Refer to "REMOVAL AND INSTALLATION ".

Check the continuity between 4WD switch assembly harness connector terminals.

CONTINUITY SPECIFICATION

4WD switch assembly		Condition	Continuity
Terminal		Condition	Continuity
12	9	4WD shift switch: AUTO	Existed
12	9	4WD shift switch: 4H or 4L	Not existed
12	10	4WD shift switch: 4H	Existed
12	10	4WD shift switch: AUTO or 4L	Not existed
12	11	4WD shift switch: 4L	Existed
12	11	4WD shift switch: AUTO or 4H	Not existed

Is the inspection result normal?

YES: INSPECTION END

NO: Replace 4WD switch assembly. Refer to "REMOVAL AND INSTALLATION ".