Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to "DIAGNOSIS PROCEDURE ".
Is the inspection result normal?
YES: GO TO 2.
NO: Repair or replace the error-detected parts.
- CHECK 4WD WARNING LAMP SIGNAL
With CONSULT-III
- Start the engine.CAUTION: Never drive the vehicle.
- Turn the 4WD shift switch AUTO=>4H=>4LO=>4H=>AUTO.
- Check "4WD MODE IND" of CONSULT-III "DATA MONITOR" for "ALL MODE AWD/4WD".MONITOR ITEM CONDITION
Monitor item Condition Status 4WD MODE IND 4WD shift switch: AUTO AUTO 4WD shift switch: 4H 4H 4WD shift switch: 4L 4L Is the inspection result normal?
YES: Check combination meter. Refer to "COMBINATION METER : DIAGNOSIS PROCEDURE ".
NO: Replace transfer control unit. Refer to "REMOVAL AND INSTALLATION ".
- Start the engine.