Work Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: In fail-safe mode, can not perform work support. (Except that DTC P181F or P182B is detected.)

PREPARATION BEFORE WORK
With CONSULT-III
1. Start the engine.
  CAUTION: Never drive the vehicle.
2. Check "4WD MODE", "T/M RANGE", "COMER VHCL SPEED", "MOTOR POWER SUP" of CONSULT-III "DATA MONITOR" for "ALL MODE AWD/4WD".
3. Continue the following condition.
  4WD MODE : 4L
  
  T/M RANGE : N
  
  COMPER VHCL SPEED : 0 km/h (Never drive the vehicle)
  
  MOTOR POWER SUP : More than 11 V
  
  GO TO 2.
PERFORM ERASE LOCK POSITION SENOR LEARNING
With CONSULT-III
1. Select "LOCK SLEEVE SENSOR INITIALIZE" of CONSULT-III "WORK SUPPORT" for "ALL MODE AWD/4WD".
2. Select "Start".
3. Wait until the motor operation stop.
  GO TO 3.
PERFORM LOCK POSITION SENOR LEARNING
With CONSULT-III
1. Select "LOCK SLEEVE SENSOR LEARNING" of CONSULT-III "WORK SUPPORT" for "ALL MODE AWD/4WD".
2. Select "Start".
3. Wait until the motor operation stop.
  GO TO 4.
PERFORM SELF-DIAGNOSIS
With CONSULT-III
1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
2. Turn the ignition switch ON to OFF.
  CAUTION: Wait for 10 seconds after turning ignition switch OFF.
3. Start the engine.
  CAUTION: Never drive the vehicle.
4. Perform self-diagnosis for "ALL MODE AWD/4WD".
  Is "DTC P182B" detected?
  
  YES: GO TO 1.
  
  NO: WORK END