Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect trunk lid lock assembly.
3. Check signal between trunk lid lock assembly harness connector and ground using oscilloscope.
   SIGNAL REFERENCE
   
   

   (+)		(-)	Signal (Reference value)
   Trunk lid lock assembly
   Connector	Terminal
   T3	1	Ground	Courtesy of NISSAN MOTOR CO., U.S.A.

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between BCM connector and trunk lid lock assembly connector.
   CONTINUITY REFERENCE
   
   

   BCM		Trunk lid lock assembly		Continuity
   Connector	Terminal	Connector	Terminal
   M121	42	T3	1	Existed

3. Check continuity between BCM connector and ground.
   CONTINUITY REFERENCE
   
   

   BCM		Ground	Continuity
   Connector	Terminal
   M121	42		Not existed

   Is the inspection result normal? 

   YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.

Check continuity between trunk lid lock assembly connector and ground.

Is the inspection result normal? 

YES: GO TO 4.

NO: Repair or replace harness.

Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: GO TO 5.

NO: Replace trunk lid lock assembly.

Refer to "INTERMITTENT INCIDENT ".

INSPECTION END