Diagnosis Procedure
- CHECK COMBINATION METER OUTPUT SIGNAL
- Connect CONSULT-III.
- Select the "Data Monitor" for the "METER/M&A" and compare the "FUEL METER" monitor value with the fuel gauge reading on the combination meter. Refer to
"COMPONENT FUNCTION CHECK ".
Does monitor value match fuel gauge reading?
YES: GO TO 2.
NO: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".
- CHECK FUEL LEVEL SENSOR SIGNAL CIRCUIT
Check the fuel level sensor signal circuit. Refer to "DIAGNOSIS PROCEDURE ".
Is the inspection result normal?
YES: GO TO 3.
NO: Repair harness or connector.
- CHECK FUEL LEVEL SENSOR UNIT
Perform a unit check for the fuel level sensor unit. Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: GO TO 4.
NO: Replace fuel level sensor unit (main or sub). Refer to "REMOVAL AND INSTALLATION ".
- CHECK FLOAT INTERFERENCE
Check that the float arm interferes with or binds to other components in the fuel tank.
Is the inspection result normal?
YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".
NO: Repair or replace malfunctioning parts.