Removal and Installation: Removal
- Always check the air bag diagnosis sensor unit ECU discriminated number (identification number) using CONSULT.
- Disconnect each connector of all air bag modules and pre-tensioner seat belts.
- Remove the center console assembly and center console rear bracket.
- A/T models: Refer to "A/T MODELS : REMOVAL AND INSTALLATION ".
- M/T models: Refer to "M/T MODELS : REMOVAL AND INSTALLATION ".
- Disconnect the diagnosis sensor unit harness connector.
- Remove the TORX bolts, ground bolt, and then remove the diagnosis sensor unit.
CAUTION:
- Replace the diagnosis sensor unit of deployed driver air bag module, deployed passenger air bag module, deployed side air bag module, deployed curtain air bag module, or deployed seat belt pretensioner.
- Never impact the diagnosis sensor unit.
- Replace the diagnosis sensor unit if it has been dropped or sustained an impact.