Removal and Installation: Installation

Install air bag diagnosis sensor unit in the reverse order of removal.

CAUTION:

Never use the old bolts after removal, replace with the new bolts.
Never damage the harness while installing.
If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT-III. Refer to "CONSULT-III FUNCTION ".
After the work is completed, check that no system malfunction is detected by air bag warning lamp.
After replacing the air bag diagnosis sensor unit, confirm using CONSULT-III that the ECU discriminated number (identification number) of the new replacement air bag sensor unit matches the ECU discriminated number (identification number) of the replaced (old) air bag diagnosis sensor unit.

NOTE: If the ECU discriminated number of the new replacement air bag diagnosis sensor unit differs from the ECU discriminated number of the replaced air bag diagnosis sensor unit, reconfirm the parts information and verify that the correct air bag diagnosis sensor unit was installed.