Removal and Installation: Removal

Remove the headlining.
- Normal roof models: Refer to "NORMAL ROOF : REMOVAL AND INSTALLATION ".
- Sunroof models: Refer to "SUNROOF : REMOVAL AND INSTALLATION ".
Remove the curtain air bag module harness connector.
CAUTION:
- For installing/removing the curtain air bag module harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove the connector.
- Install the connector with lock raised, and push lock into the connector.
- After installing the connector, check that the lock is pushed securely into it.
  
  Fig 1: Removing Curtain Air Bag Module Harness Connector
  Courtesy of NISSAN MOTOR CO., U.S.A.
Remove fixing bolts, and then remove the curtain air bag module.

CAUTION:

Never impact the curtain air bag module.
Replace the curtain air bag module if it has been dropped or sustained an impact.

Fig 2: Precaution For Handling Curtain Air Bag Module
Courtesy of NISSAN MOTOR CO., U.S.A.
Never insert any foreign objects (screwdriver, etc.) into the curtain air bag module.
Never disassemble the curtain air bag module.
Never expose the curtain air bag module to temperatures exceeding 90°C (194°F).
Never allow oil, grease, detergent, or water to come in contact with the curtain air bag module.