LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> G37 IPL, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 66 (Transfer Case -- G37 Coupe) >> Unit Disassembly And Assembly >> Front Drive Shaft And Drive Chain >> Assembly

Front Drive Shaft And Drive Chain: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install plug to front drive shaft.
    CAUTION: Never reuse plug.
  2. Install front drive shaft rear bearing with the drift (A) [SST: ST33200000 (J-26082)].
    Fig 1: Installing Front Drive Shaft Rear Bearing With Drift
    G05979454Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Install front drive shaft front bearing with the drift (A) [SST: KV38104010 (-)].
    Fig 2: Installing Front Drive Shaft Front Bearing With Drift
    G05979455Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Set drive chain to front drive shaft.
    CAUTION: Identification mark (A) of drive chain should be in the side of front bearing (1) of front drive shaft.
  5. Install drive chain to main shaft, and then install front drive shaft.
    CAUTION: Never use tools. Always install by hand.
  6. Install front case to rear case. Refer to "ASSEMBLY ".
Fig 3: Locating Identification Mark Of Drive Chain In Side Of Front Bearing Of Front Drive Shaft
G05727203Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals