Data Monitor
WARNING: This page is about a different variant/trim than selected.
Display Item List
DATA MONITOR CHART
| Monitor item (Unit) | Remarks |
|---|---|
| STOP LAMP SW [On/Off] | Stop lamp switch signal status via CAN communication line is displayed. |
| ENG SPEED SIG [Run/Stop] | Engine status is displayed. |
| ETS ACTUATOR [On/Off] | Operating condition of AWD actuator relay (integrated in AWD control unit) is displayed. |
| 4WD WARN LAMP [On/Off] | Control status of AWD warning lamp is displayed. |
| 4WD MODE SW [##] | Mode switch is not equipped, but displayed. |
| 4WD MODE MON [AUTO] | Control status of AWD is displayed. |
| DIS-TIRE MONI [mm] | Improper size tire installed condition is displayed. |
| P BRAKE SW [On/Off] | Parking brake switch signal status via CAN communication line is displayed. |
| BATTERY VOLT [V] | Power supply voltage for AWD control unit |
| THRTL POS SEN [%] | Throttle opening status is displayed. |
| ETS SOLENOID [A] | Monitored value of current at AWD solenoid |
| FR RH SENSOR [km/h] or [mph] | Wheel speed calculated by front RH wheel sensor signal is displayed. |
| FR LH SENSOR [km/h] or [mph] | Wheel speed calculated by front LH wheel sensor signal is displayed. |
| RR RH SENSOR [km/h] or [mph] | Wheel speed calculated by rear RH wheel sensor signal is displayed. |
| RR LH SENSOR [km/h] or [mph] | Wheel speed calculated by rear LH wheel sensor signal is displayed. |
ACTIVE TEST
Description
Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT-III to check operation of actuator.
Test Item
TEST ITEM DESCRIPTION CHART
| Test item | Condition | Description |
|---|---|---|
| ETS S/V (Detects AWD solenoid) |
|
Change command current value to AWD solenoid, and then change driving mode. (Monitor value is normal if it is within approx. ±10% of command value.)
|
CAUTION:
Never energize continuously for a long time.