Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM SELF-DIAGNOSIS
With CONSULT-III
Perform self-diagnosis for "ALL MODE AWD/4WD".
Is any DTC detected?
YES: Check the DTC.
NO: Go to 2.
- CHECK AWD WARNING LAMP
Perform the trouble diagnosis of the AWD warning lamp. Refer to "DIAGNOSIS PROCEDURE ".
Is the inspection result normal?
YES: Go to 3.
NO: Repair or replace the error-detected parts.
- CHECK AWD CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis of the power supply and ground circuit. Refer to "DIAGNOSIS PROCEDURE ".
Is the inspection result normal?
YES: Check each harness connector pin terminal for malfunction or disconnection.
NO: Repair or replace the error-detected parts.