Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK TIRE
Check the following.
- Tire pressure
- Wear condition
- Front and rear tire size (There is no difference between front and rear tires.)
Is the inspection result normal?
YES: Go to 2.
NO: Repair or replace error-detected parts. And then, drive the vehicle at speed of 20 km/h (12 MPH) or more for 5 seconds or more. Improper size information is initialized accordingly.
- CHECK INPUT SIGNAL OF TIRE DIAMETER
With CONSULT-III
- Start the engine.
- Drive at 20 km/h (12 MPH) or more for approximately 4 minutes.
- Check "DIS-TIRE MONI" of CONSULT-III "DATA MONITOR" for "ALL MODE AWD/4WD".
Does the item on "DATA MONITOR" indicate "0 - 4 mm"?
YES: INSPECTION END
NO: Go to 3.
- TERMINAL INSPECTION
Check AWD control unit harness connector for disconnection.
Is the inspection result normal?
YES: Replace AWD control unit. Refer to "EXPLODED VIEW ".
NO: Repair or replace the error-detected parts.