High And Low Reverse Clutch: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove bearing race from high and low reverse clutch drum.

Fig 1: Removing Bearing Race From High And Low Reverse Clutch Drum
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove snap ring from high and low reverse clutch drum using a flat-bladed screwdriver.
CAUTION:
- Be careful not to scratch high and low reverse clutch drum.
- Be careful not to damage snap ring.
Remove high and low reverse clutch component part (drive plates, driven plates, retaining plate and dish plate) from high and low reverse clutch drum.

Fig 2: Removing Snap Ring From High And Low Reverse Clutch Drum Using Flat-Bladed Screwdriver
Courtesy of NISSAN MOTOR CO., U.S.A.