High And Low Reverse Clutch: Assembly

WARNING: This page is about a different variant/trim than selected.

Install high and low reverse clutch component part (drive plates, driven plates, retaining plate, dish plate and snap ring) in high and low reverse clutch drum.

Fig 1: View Of Snap Ring, Retaining Plate, Drive Plate, Driven Plate And Dish Plate
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Check the order of plates.
Install snap ring in high and low reverse clutch drum using a flat-bladed screwdriver.
CAUTION:
- Be careful not to scratch high and low reverse clutch drum.
- Be careful not to damage snap ring.
  
  Fig 2: Installing Snap Ring To High And Low Reverse Clutch Drum Using Flat-Bladed Screwdriver
  Courtesy of NISSAN MOTOR CO., U.S.A.
Install bearing race to high and low reverse clutch drum.
CAUTION: Check the direction of needle bearing. Refer to "LOCATION OF NEEDLE BEARINGS AND BEARING RACES ".

Fig 3: Installing Bearing Race To High And Low Reverse Clutch Drum
Courtesy of NISSAN MOTOR CO., U.S.A.