Front Carrier, Input Clutch, Rear Internal Gear: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove needle bearing (1) from front carrier assembly.

Fig 1: Locating Front Carrier Assembly Needle Bearing
Courtesy of NISSAN MOTOR CO., U.S.A.
Compress snap ring (1) using flat-bladed screwdrivers (A).
CAUTION:
- Be careful not to scratch rear internal gear.
- Be careful not to damage snap ring.
Remove front carrier assembly and input clutch assembly from rear internal gear.
Remove front carrier assembly from input clutch assembly.

Fig 2: Pressing Snap Ring Using Flat-Bladed Screwdriver
Courtesy of NISSAN MOTOR CO., U.S.A.

6. Remove snap ring (1) from front carrier assembly.
CAUTION: Be careful not to expand snap ring excessively.

Fig 3: View Of Front Carrier Assembly Snap Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
7. Remove O-ring (1) and seal rings (2) from input clutch assembly.

Fig 4: Locating Input Clutch Assembly O-Ring And Seal Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
8. Remove needle bearing from input clutch assembly.

Fig 5: Removing Needle Bearing From Input Clutch Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.
9. Remove snap ring from input clutch drum using a flat-bladed screwdriver.
CAUTION:
- Be careful not to scratch rear input clutch drum and input clutch retaining plate.
- Be careful not to damage snap ring.
10. Remove input clutch component part (drive plates, driven plates, retaining plate and dish plate) from input clutch drum.

Fig 6: Removing Snap Ring From Input Clutch Drum Using Flat-Bladed Screwdriver
Courtesy of NISSAN MOTOR CO., U.S.A.