Consult-III Application Items

WARNING: This page is about a different variant/trim than selected.

CONSULT-III FUNCTION REFERENCE CHART

Diagnostic test mode

Function

Self Diagnostic Results

Retrieve DTC from ECU and display diagnostic items.

Data Monitor

Monitor the input/output signal of the control unit in real time.

CAN Diagnosis

This mode displays a network diagnosis result about CAN by a diagram.

CAN Diagnostic Support Monitor

It monitors the status of CAN communication.

DTC & SRT confirmation

The status of system monitoring tests and the self-diagnosis status/result can be confirmed.

ECU Identification

Display the ECU identification number (part number etc.) of the selected system.

Function Test⁽¹⁾

This mode can show results of self-diagnosis of ECU with either "OK" or "NG". For engine, more practical tests regarding sensors/switches and/or actuators are available.

Special Function⁽¹⁾

Other results or histories, etc. that are recorded in ECU are displayed.

⁽¹⁾	Although "Function Test" and "Special Function" are selectable, do not use its.