Inspection and Adjustment: Adjustment

WARNING: This page is about a different variant/trim than selected.

Loosen nut (<=).
- 2WD models
  
  Fig 1: Loosening Lower Lever Nut (2WD Models)
  Courtesy of NISSAN MOTOR CO., U.S.A.
- AWD models
  
  Fig 2: Loosening Lower Lever Nut (AWD Models)
  Courtesy of NISSAN MOTOR CO., U.S.A.
Place manual lever and selector lever in "P" position.
While pressing lower lever (A) toward rear of vehicle (in "P" position direction), tighten nut to specified torque. Refer to "2WD : EXPLODED VIEW " (2WD) or "AWD : EXPLODED VIEW " (AWD).
CAUTION: Be careful not to touch the control rod while pressing lower lever of A/T shift selector assembly.

NOTE: Press lower lever of A/T shift selector assembly with a force of approximately 1 kg (9.8 N).