Component Inspection (Selector Lever Position Indicator)

WARNING: This page is about a different variant/trim than selected.

CHECK SELECTOR LEVER POSITION INDICATOR

Check that selector lever position indicator lamps turn on.

CAUTION: Connect the fuse between the terminals when applying the voltage.

SELECTOR LEVER POSITION INDICATOR CONNECTOR REFERENCE CHART

Selector lever position indicator connector			Condition	Status
Connector	Terminal
Connector	+ (fuse)	-
M221	2	7	Apply 12 V direct current between terminals 2 and 7.	"N" position indicator lamp turns on.
	3		Apply 12 V direct current between terminals 3 and 7.	"D" position indicator lamp turns on.
	4		Apply 12 V direct current between terminals 4 and 7.	"R" position indicator lamp turns on.
	5		Apply 12 V direct current between terminals 5 and 7.	"P" position indicator lamp turns on.
	6	9	Apply 12 V direct current between terminals 6 and 9.	"M" mode indicator lamp turns on.
	10	11	Apply 12 V direct current between terminals 10 and 11.	Illumination lamp turns on.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace the selector lever position indicator. Refer to "REMOVAL AND INSTALLATION ".