DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
Go to 2.
- CHECK DTC DETECTION
With CONSULT-III
- Start the engine.
- Run engine for at least 2 consecutive seconds at idle speed.
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT-III"
Is "U1000" detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END