DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

Go to 2.
CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "BATTERY VOLT", "MANU MODE SW", "GEAR" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Drive the vehicle and maintain the following conditions for 5 seconds or more.
  BATTERY VOLT : 9 V or more
  
  MANU MODE SW : ON
  
  GEAR : 3rd
  
  VHCL/S SE-A/T : 10 km/h (7 MPH) or more
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST

Follow the procedure "With CONSULT-III".

Is "P2713" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END