DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

Go to 2.
CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "SLCT LVR POSI" and "MANU MODE SW" in "Data Monitor" in "TRANSMISSION".
3. Maintain the following each conditions more than 60 seconds.
  SLCT LVR POSI : D
  
  MANU MODE SW : ON
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
  Is "P1815" detected?
  
  YES: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END