Component Inspection (Manual Mode Switch)

WARNING: This page is about a different variant/trim than selected.

CHECK MANUAL MODE SWITCH

Check continuity between A/T shift selector harness connector terminals.

CONTINUITY REFERENCE CHART

A/T shift selector harness connector			Condition	Continuity
Connector	Terminal		Condition	Continuity
M137	1	4	Selector lever is shifted to manual shift gate side	Existed
	1		Other than the above	Not existed
	2		Selector lever is shifted to - side	Existed
	2		Other than the above	Not existed
	3		Selector lever is shifted to + side	Existed
	3		Other than the above	Not existed
	5		Selector lever is shifted to manual shift gate side	Not existed
	5		Other than the	above Existed

Is the inspection result normal?

YES: INSPECTION END

NO: Repair or replace damaged parts. Refer to "2WD : EXPLODED VIEW " (2WD) or "AWD : EXPLODED VIEW " (AWD).